What are the construction methods for polyester fiber acoustic panels

1. Wall construction method:

When installing the polyester fiber acoustic panel with a reserved cavity on the wall, you can choose a straight-type light steel keel as the back-attached keel. On the finished solid wall additional wall keel, glue the polyester fiber acoustic panel, or connect it with the light steel keel by pattern nailing. Good flatness and strong stability.

The method of directly pasting on the solid wall is as follows:

1. Pay attention to panel selection and typesetting before construction

Pay attention to the slight chromatic aberration, find the center point of the pasted surface, draw a cross line, and use the bricklaying method to start typesetting from the center point.

2. cutting the surface.

Use a steel ruler and a sharp utility knife to cut and modify accordingly. If you want to reduce the seam, you can tilt the blade 0.5-1MM inward when cutting. This can facilitate the butt joint of the panel edges and reduce the gap.

3. paste

(1) Cement or wood base surface; Benzene-free universal glue or white latex with rubber as raw material can be used.

(2) Paper-faced gypsum panel base surface: White latex or wallpaper glue that has cellulose as raw material can be used under the premise of not being easily damp. Surface movement). Under the premise of easy or possible dampness, universal glue can be used.

(3) Polyester fiber acoustic panel is a porous material, which is especially easy to absorb glue, which causes clogging of the holes and affects the acoustic function of the rear cavity. It is recommended to apply glue on one side during construction (only apply glue on the substrate and keel, the amount of glue is slightly heavier than usual). It can also be reinforced with nails.